issue : eryone PLA filement 1.90 mm

Post Reply
mameyoud
Posts: 2
Joined: Sun Jan 12, 2020 3:30 am

issue : eryone PLA filement 1.90 mm

Post by mameyoud » Sun Jan 12, 2020 3:45 am

Hi,

I got recently a PLA filement blue. after wasting a lot of filement and lost printings , I tried to mesure a diam and finaly I found 1.90 mm.

I followed advises on the web to correct the flow. I set up flow to 90% after that I printed calibration cube. after mesuring xyz i found 21.5mm instead 20mm. I corrected the flow to 75%.

Could eryone solve me this issues by new correct spool.

many thanks for helps
Mourad

User avatar
Eryone
Site Admin
Posts: 29
Joined: Wed May 08, 2019 6:50 pm

Re: issue : eryone PLA filement 1.90 mm

Post by Eryone » Thu Jan 16, 2020 9:28 am

Hi, thanks for your feedback.
You can refer to these tips to get a 20mm cube:
Refer to this formula and check the stepper/mm values
eg: X/Y is 80, Z is 400, E is 93
We use the E value to find out the new values
(20mm x 93mm)/(21.5mm)=86.51
You can set the E value to 86.51 then save it.

Post Reply