[Resumer 3D]Anet A8 with resumer 3d

Post Reply
William
Posts: 19
Joined: Fri May 10, 2019 3:40 pm

[Resumer 3D]Anet A8 with resumer 3d

Post by William » Thu Nov 07, 2019 2:06 am

If you are using the resumer 3d for your Anet A8.
You need to refer to these steps:
1. Upload the Marlin1.1.9 firmware for Anet A8
2. Restart the printer
1) Use the M502 and M500 to initialization the EEPROM
2) Insert the SD card
3) Click "Initialization SD card" on LCD
3. Test it work or not

If you have any questions please reply to this post!

Post Reply