ER-20 and Simplyfy3d

[GadgetGuy]

Hi,

I just received my new ER-20, set it up and printed the 3 test files from the SD card.

They print perfectly.

I then went to use my usual slicer (Simplyfy3D) and I can't get anything to print properly.

I can't even get a first layer to work.

Tried printing the sample files again, no issue.

So it must be Simplyfy3D.

My method is to slice in S3D, save paths to my SD Card, and print from the SD Media on the printer.

I am using the S3D profile that was sent to me by Eryone, but are there other settings I need to be adjusting?

Your help would be greatly appreciated.

Thanks,
D

[Dawood]

First of all, you may try to use the Start and End G-code that is attached below.
Kindly share some pictures of the failed prints or a video link showing the failures. We will reply to you on the basis of that

ER20-Start-&-End G-code.rar

(447 Bytes) Downloaded 15 times