Thinker SE glass bed: Preferred Side?

When you find your machine has problems. You can have a look at this section
Post Reply
ThePrimate
Posts: 5
Joined: Fri Jan 15, 2021 1:23 am

Thinker SE glass bed: Preferred Side?

Post by ThePrimate » Fri Feb 26, 2021 1:02 am

We were lucky and got two thinker SE's v2 partially disassembled a few months back. I got one up and going but noticed just this morning that the glass bed has indentations or something on one side, smooth glass on the other. Now I've been printing with the smooth glass down (this is the way it came to us) I notice the other printer (still partially disassembled)has the smooth glass side up. Which side should I be using or does each side have a different use?

TIA

User avatar
William
Site Admin
Posts: 248
Joined: Fri May 10, 2019 11:40 pm

Re: Thinker SE glass bed: Preferred Side?

Post by William » Fri Feb 26, 2021 9:23 am

Hi, about the question"Which side should I use?"
You can refer to this:
1. If the filament can stick very well at different texture surface
Then you can use both of them
2. If the filament can't stick very well at the matte texture surface
Then you should use the smooth side.

How about the matte texture surface advantage?
The prints can be removed easy when you finished the printing but smooth side will be a bit difficult to remove the prints.


Greeting
## To be friendly and stay humble
- Pride and ignorance are eternal enemies
:)

Post Reply