[FAQ Thinker] Leveling Your Heatbed

When you find your machine has problems. You can have a look at this section
Post Reply
User avatar
Eryone
Site Admin
Posts: 22
Joined: Wed May 08, 2019 10:50 am

[FAQ Thinker] Leveling Your Heatbed

Post by Eryone » Mon Sep 16, 2019 3:06 am

Leveling Your Heatbed
1.Manual leveling
1)Ensure the distance between the nozzle and heatbed more than 5mm
If the nozzle hit the heatbed,you can refer to these steps:
Click LCD buttom>Prepare>Move Z axis

2)Click LCD buttom>Prepare>Auto home

3)There are tow way to leveling your heatbed

The first one is: Click LCD buttom>Prepare>Disable the stepper>
Move the hotend to 4 corners of the heatbed with your hands

The second one is: Click LCD buttom>Prepare>Level bed
You can choose the way you like.

4)Adjust the knob of the heatbed

Check this pic to tuning your heatbed leveling
Level.jpg
Level.jpg (26.85 KiB) Viewed 261 times

2.Auto-leveling
Note:
The default eryone thinker 3d printer doesn't inculded bltouch/Npn sensor.
If you want to use the auto leveling, you need to purchase the bltouch/npn sensor.


Refer to this link you can get the guide+firmware for bltouch/npn sensor on the thinker.
viewtopic.php?f=6&t=5&p=5#p5

Post Reply