Stepper Motor

When you find your machine has problems. You can have a look at this section
Post Reply
Sweendal
Posts: 4
Joined: Thu Feb 13, 2020 4:45 am

Stepper Motor

Post by Sweendal » Wed Feb 19, 2020 7:09 am

Hi

I have a problem with the stepper motor from the extruder. When I switch on the printer, I can move the motor about 10 cm in the move axis extruder menu. Every time it starts to move, there is a single click sound from the stepper motor. after about 10 * 10mm steps, the motor no longer moves until a power reset. I think the stepper motor is broken. can someone tell me what replacement i can buy? that of Crealitiy 10s per?
https://www.amazon.de/3Wthings-Schrittm ... D%C3%95%C3 % 91 & keywords = stepping motor Creality + + + 10s per & qid = 1582067140 & sr = 8-19

Thank you
Sweendal

Domhol26
Posts: 8
Joined: Mon Jan 06, 2020 12:45 am
Location: Germany

Re: Stepper Motor

Post by Domhol26 » Wed Feb 19, 2020 2:51 pm

Good Morning from Germany,

i had the same problem.
Please read my post:
https://www.eryone.com/forum/viewtopic. ... t=204#p380
You have to add

Code: Select all

M900 K0
in the startcode of your slicer.

Greetings

DomHol

Sweendal
Posts: 4
Joined: Thu Feb 13, 2020 4:45 am

Re: Stepper Motor

Post by Sweendal » Wed Feb 19, 2020 10:11 pm

Ich danke dir wieder einmal.
Hat geklappt. It works.

Thanks

Post Reply