How to upload the firmware to your Printer

You can find the firmware for Eryone 3d printer at this section
Post Reply
Site Admin
Posts: 31
Joined: Fri May 10, 2019 11:40 pm

How to upload the firmware to your Printer

Post by William » Sat May 11, 2019 3:52 pm

Here are the step by step guide of how to upload the firmware to your printer
1.Download the Arduino IDE and install it
The Arduino IDE offical website:

2. If you are first using it,you need to download it from here(If you are not the first time using it then skip this step and see the step of 3):
Arduino_1.png (72.67 KiB) Viewed 1567 times
Open the Arduino add the “U8glib“” to your library
Arduino_2.png (126.84 KiB) Viewed 1567 times
Arduino_3.png (37.42 KiB) Viewed 1567 times
3.1)Choose the correct board type and processor
Arduino_4.png (75.03 KiB) Viewed 1567 times
2)Plug the USB cable to your PC/laptap
If you haven’t install the usb drives for your printer.You can refern to this link:
3)Choose the correct COM port
Arduino_5.png (71.33 KiB) Viewed 1567 times
4)Open the firmware and upload it to your printer
Arduino_6.png (65.74 KiB) Viewed 1567 times
“File”>”Open”>“Marlin-BLTouch”>”Marlin”>”Marlin.ino”Click upload button
Arduino_7.png (36.04 KiB) Viewed 1567 times
4.When Arduino IDE shows Done uploading you can remove the cables of USB off

Post Reply