How to upload the firmware to your Printer

You can find the firmware for Eryone 3d printer at this section
Post Reply
Site Admin
Posts: 38
Joined: Fri May 10, 2019 11:40 pm

How to upload the firmware to your Printer

Post by William » Sat May 11, 2019 3:52 pm

Here are the step by step guide of how to upload the firmware to your printer
1.Download the Arduino IDE and install it
The Arduino IDE offical website:

2. If you are first using it,you need to download it from here(If you are not the first time using it then skip this step and see the step of 3):
Arduino_1.png (72.67 KiB) Viewed 2396 times
Open the Arduino add the “U8glib“” to your library
Arduino_2.png (126.84 KiB) Viewed 2396 times
Arduino_3.png (37.42 KiB) Viewed 2396 times
3.1)Choose the correct board type and processor
Arduino_4.png (75.03 KiB) Viewed 2396 times
2)Plug the USB cable to your PC/laptap
If you haven’t install the usb drives for your printer.You can refern to this link:
3)Choose the correct COM port
Arduino_5.png (71.33 KiB) Viewed 2396 times
4)Open the firmware and upload it to your printer
Arduino_6.png (65.74 KiB) Viewed 2396 times
“File”>”Open”>“Marlin-BLTouch”>”Marlin”>”Marlin.ino”Click upload button
Arduino_7.png (36.04 KiB) Viewed 2396 times
4.When Arduino IDE shows Done uploading you can remove the cables of USB off

If your printer motherboard is thinker V2 then you can refer to this video
then upload it


Post Reply