Problem homing with inductive sensor

You can find the firmware for Eryone 3d printer at this section
Post Reply
hhenrygaron
Posts: 2
Joined: Mon Aug 24, 2020 7:24 pm

Problem homing with inductive sensor

Post by hhenrygaron » Mon Aug 24, 2020 7:30 pm

Hi, i followed the eryone video on youtube on how to use the inductive sensor. I used this firmware : https://github.com/Eryone/mega2560/tree ... mware-Beta

I opened the config folder, and i copied the two files inside the BX sensor folder. I replaced by the ones in the Marlin folder. I use platformio to build and then upload. All good, then i connected the sensor and i tested with a metal piece under, the red light comes on.

I did the 502,501,500 commands and i tried to home axis but it will never stop. Any idea?

**i have the thinker s v2.0.

Thanks

User avatar
William
Site Admin
Posts: 170
Joined: Fri May 10, 2019 11:40 pm

Re: Problem homing with inductive sensor

Post by William » Fri Nov 20, 2020 8:43 pm

Hi,
sorry for the late.
I think the new version fixed this problem.
You can have look with it.
:d
## To be friendly and stay humble
- Pride and ignorance are eternal enemies
:)

Post Reply