how to enable UART mode for TMC2208/2209 drivers on Thinker 2560 MB

You can find the firmware for Eryone 3d printer at this section
Post Reply
shahan
Posts: 1
Joined: Fri Apr 03, 2020 1:20 pm

how to enable UART mode for TMC2208/2209 drivers on Thinker 2560 MB

Post by shahan » Fri Apr 03, 2020 1:22 pm

I recently ordered Eryone TMC 2209 stepper drivers, looking for a way to use them with UART mode. Do we have documentation for this setup ?

Shahan

User avatar
William
Site Admin
Posts: 110
Joined: Fri May 10, 2019 11:40 pm

Re: how to enable UART mode for TMC2208/2209 drivers on Thinker 2560 MB

Post by William » Fri Jun 19, 2020 4:23 pm

Hi,
You can refer to this link:
https://github.com/Eryone/mega2560/tree ... mware-Beta

Then you can find out the guide of the TMC2209 with Thinker V2(Thinker SE use the V2 motherboard)
Also, the firmware is prepared for all the users, so just flash it and refer to the manual do some adjustments will be ok.
:roll:
## To be friendly and stay humble
- Pride and ignorance are eternal enemies
:)

Post Reply