Page 1 of 1

Pb bltouch. Help

Posted: Mon Dec 02, 2019 5:40 pm
by Kouba
Hi.
the firmware does not work for the bltouch .. impossible to put a negative value on the z for the configuration.

Sorry for my english, i french.

Re: Pb bltouch. Help

Posted: Tue Dec 03, 2019 3:16 pm
by William
Hi, good day
Could you attach the details of it?
1) The bltouch version
2) Firmware link
3) The log file about the bltouch
We need to refer to these then we can get more details from it.
Cheers

Re: Pb bltouch. Help

Posted: Tue May 19, 2020 3:31 am
by newto3D
You have to disable the soft bump stops on the printer, if you connect to the printer in S3D go to machine settings and run code M211 S0 you will get a reply that states the soft stops are disabled, you can then use negative value for the Z axis