Thinker S V2.1 5015 Fan

Post Reply
Retris
Posts: 3
Joined: Thu Jan 09, 2020 4:22 pm

Thinker S V2.1 5015 Fan

Post by Retris » Sun Mar 01, 2020 3:30 am

Hi there,

I have connected a 5015 fan 24V for cooling. The original fan runs on 5V. Do you have sketches and pin assignments for the V2.1 board so that I can get the 5015 up and running?
Or can I switch using jumpers?

regards

William
Site Admin
Posts: 42
Joined: Fri May 10, 2019 11:40 pm

Re: Thinker S V2.1 5015 Fan

Post by William » Mon Mar 02, 2020 10:34 am

Hi, my friend. You can check set the correct jumpers then the FAN0/FAN1/FAN2/FAN3 port voltage will be changed to the 12V/24V
(In fact,it is a switch of 5V/24V. Because if you wants it runs at 12V then you need to change the PSU).
The default jumpers mean the electric runs 5V cooling fan:
2560V2_5V.png
2560V2_5V.png (1.9 MiB) Viewed 582 times
If you want them runs at 24V(All the fan port voltage will be changed to 24V, expect the board cooling fan):
2560V2_24V.png
2560V2_24V.png (1.13 MiB) Viewed 582 times
2560V2_MB cooling fan.png
2560V2_MB cooling fan.png (1.9 MiB) Viewed 582 times

Retris
Posts: 3
Joined: Thu Jan 09, 2020 4:22 pm

Re: Thinker S V2.1 5015 Fan

Post by Retris » Fri Mar 20, 2020 10:19 pm

Hi,

thank you, I'll try that

regards

Post Reply