Hey

Introduce yourself to us and other members here, or share your own product reviews, suggestions, and tips and tricks of using Eryone products.
Post Reply
rozhen87
Posts: 3
Joined: Fri May 22, 2020 12:11 am

Hey

Post by rozhen87 » Sat May 23, 2020 3:29 pm

Hiya, I am Brad. Got a Thinker SE Thursday. Never printed or sliced anything before. 12 hours of learning the basics and my printer is killing it. I cannot wait to see how good things get when i learn how tune better. I will recommend Eryone to everyone. My next printer will be from here as well.

Image attached is my first full print that was successful. Painted without any sanding or pre-prep. Left printer for a few hours alone and had a small issue in the infill. The nozzle or filament was dragging a little but it cleared up at the end once i drew back some flow rate and nozzle temp.
Attachments
20200523_032309.jpg
20200523_032309.jpg (2.98 MiB) Viewed 20 times

Post Reply