Search found 2 matches

by A_Snatcher
Mon Sep 09, 2019 4:30 am
Forum: Stepper Drivers
Topic: Need better info on UART
Replies: 3
Views: 3754

Re: Need better info on UART

Well then, I'm at a loss. I just put the E0 into legacy because UART would not function.
It's functioning, but I'm disappointed at the loss of remote adjustments.
Thanks for the reply.
by A_Snatcher
Fri Sep 06, 2019 1:53 am
Forum: Stepper Drivers
Topic: Need better info on UART
Replies: 3
Views: 3754

Need better info on UART

I have been through the whole of the internet looking for an answer on the proper way to configure your TMC2208 v1.2 . Which pins need soldering? I have connected the two pins in the three pin set as shown in your photo. Do I need to solder anything on top? My board is BIQU SKR 1.3 and I cannot get ...